Removing and installing bearing bush: VW Polo 6C (CJXB, CJXC, CYFB)

🧭 Before you start

Fits: VW Polo 6C (2014–2017); platform code 121

• Renewed: pivot pin

Don't miss

• Turn plunger of clutch master cylinder so that recesses (1) or marking (2) become visible.

🔧 Engine codes this applies to

📋 Procedure

1. Remove over-centre spring/extension spring .
2. Compress catches (arrows) and take out pin (1) towards right side.
3. Pull clutch pedal into passenger compartment as far as stop.
4. Compress fasteners on pivot pin for plunger of master cylinder on clutch pedal. Pull off pin towards left.
5. Observe extension spring .

6. Pull clutch pedal into passenger compartment as far as stop. If necessary, remove clutch pedal switch F36 to do so.
7. Turn plunger of clutch master cylinder so that recesses (1) or marking (2) become visible.
8. Remove bearing bush (A) from recesses (1).
9. Turn plunger of clutch master cylinder so that recesses (1) or marking (2) become visible.
10. Fit and swivel bearing bush (A) into recesses (1).
11. Install over-centre spring/extension spring .
12. Connect plunger/clutch master cylinder to clutch pedal.
13. Use new pivot pin.
14. Observe extension spring .
15. Install clutch pedal switch F36 if removed beforehand .
16. Connect battery Electrical system27Battery; Disconnecting and connecting battery.

Other VW procedures

• Checking selector mechanism – VW Golf VII / Passat B8 2.0
• Removing and installing right flange shaft · 2 torque figures
• Removing and installing catalytic converter – VW Polo 6C
• Removing and installing coolant shut-off valve N82 – VW · 2 torque figures
• Renewing needle bearing (polygon bearing) and oil seal for right flange shaft
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures