Removing and installing backrest release motors: VW Touareg II
Step-by-step removing and installing backrest release motors for the VW Touareg II: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Remove screws (1) and (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition.
- Remove bench seats .
- Remove rear seats .
- Remove screws (1) and (2) (2 Nm). — 2 Nm (1.5 lb-ft)
- Open motor (3) and detach Bowden cable.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing clutch in conjunction with Sachs dual-mass flywheel
- Repairing selector mechanism – VW Polo 6C 2.0
- Removing and installing gearbox oil cooler – VW 2.0
- 5-speed manual gearbox 02C, four-wheel drive — Renewing propshaft flange oil seal on rear final drive (final drive removed)
- Removing and installing starter, vehicles with 2.0 l TDI engine, 103 kW, manual gearbox MQ350
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.