Removing and installing ancillary bracket for air conditioner compressor, engine codes BUB, CBRA and CDVA — VW

🧭 Before you start

Fits: platform code 1F7

Don't miss

• When installing poly V-belt, ensure that it is correctly seated on poly V-belt pulley.Finally, place poly V-belt over pulley of air conditioner compressor.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Loosen air conditioner compressor and remove hexagon bolt (9). Remove air conditioner compressor from ancillary bracket and secure to body with suitable material (e.g. welding wire).
2. Unscrew bolts from ancillary assembly bracket.
3. Secure air conditioner compressor (1) to body with suitable material (e.g. welding wire (2)). [Note: When installing poly V-belt, ensure that it is correctly seated on poly V-belt pulley.Finally, place poly V-belt over pulley of air conditioner compressor.] [Note: Bolts (1) and (2) are fit bolts.]
4. First tighten bolts in sequence 1 to 5 hand-tight.
5. Then tighten bolts to 25 Nm in sequence 1 to 5. — 25 Nm (18 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures