Removing and installing adaptive suspension valve blockNX7 — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

📋 Procedure

1. Remove air from accumulator with the vehicle diagnosis system, testing and information systemVAS 5051B.
2. Activate car jacking mode and place vehicle on lifting platform.
3. Clean area around pressure retention valve at air spring struts at front.
4. Unscrew air lines from pressure retention valves of air spring struts at front (1).
5. Clean area around pressure retention valve at air spring struts at rear.

6. Unscrew air lines from pressure retention valves of air spring struts at rear (1).
7. Remove underbody panelling on right General Body Repairs - Exterior50Underbody panelling
8. Separate connector (1) from adaptive suspension valve blockNX7.
9. Unscrew air lines (1) to (6) from adaptive suspension valve blockNX7.
10. Unscrew bolts (arrows), lower compressor together with adaptive suspension valve blockNX7(1) approx. 10 cm and then secure.
11. Undo bolts (arrows) and remove adaptive suspension valve blockNX7.
12. Fill accumulator with the vehicle diagnosis system, testing and information systemVAS 5051B.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Height adjuster - remove and install · 2 torque figures
• VW Changing oil and filter gearbox removal & installation · 1 torque figures
• Rear speed sensor cables (Gol e Voyage) - remove and install · 1 torque figures
• Gear identification sensor G604 · 1 torque figures
• Air conditioning capacitor - remove and install · 1 torque figures