Removing and installing compressor without adaptive suspension valve blockNX7 — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

📋 Procedure

1. Remove air from accumulator with the vehicle diagnosis system, testing and information systemVAS 5051B.
2. Activate car jacking mode and place vehicle on lifting platform.
3. Remove underbody panelling on right General Body Repairs - Exterior50Underbody panelling
4. Remove clip (arrow) and detach intake line (1).
5. Unclip and unplug connectors (1) and (2) between compressor and body.

6. Remove air lines (1) and (2) from compressor.
7. Remove cable ties (arrows).
8. Unscrew nuts (1) for compressor.
9. Unscrew bolts (arrows) and swivel compressor with bracket (1) downwards and secure.
10. Low compressor with bracket at front until compressor can be removed.
11. ⚠ Make absolutely sure that the adaptive suspension valve blockNX7 is taken as small a distance as possible away from the underbody.In addition, it must be ensured that the air lines are never kinked or stretched. — Fill accumulator with the vehicle diagnosis system, testing and information systemVAS 5051B.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Servicing additional water heater -B7W/D7W-
• Removing and installing cylinder head cover with camshaft
• 4-cylinder diesel engine (common rail) — Checking glow plug system · 1 torque figures
• Adjusting sunroof glass panel height · 1 torque figures
• Removing and installing upper A-pillar trim – VW Jetta VI · 1 torque figures