Removing and installing activated charcoal filter (engine code BPY) — VW

🧭 Before you start

Fits: VW Golf V / Jetta (1K, 2003–2009); platform code 1F7

Don't miss

• A reinforcement plate is installed in the Eos. To loosen and tighten securing bolts (B), use T-bar and 10 mm socket3185.

🔧 Engine codes this applies to

📐 64 workshop diagrams for BPY

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove centre and rear silencers.
2. Remove heat shield (arrows).
3. Position engine and gearbox jackV.A.G 1383 A below rear axle to support.
4. Loosen securing bolts of rear axle (arrows) and unscrew them approx. 20 mm.
5. Lower rear axle slowly using engine and gearbox jackV.A.G 1383 A.

6. Pull off breather lines (A) by pressing release tab.
7. Unscrew bolts (B). [Note: A reinforcement plate is installed in the Eos. To loosen and tighten securing bolts (B), use T-bar and 10 mm socket3185.]
8. Release retaining tabs (A) using a screwdriver. Turn activated charcoal filter approx. 90° to right (B) and remove activated charcoal filter.
9. Fit breather lines so that they engage audibly.
10. Install rear axle Running gear42.

Other VW procedures

• Removing and installing toothed belt (vehicles with separate toothed belt covers)
• Removing cylinder head
• VW 2.0 timing belt replacement
• VW Passat5 TFSI, split cover, 2007 2.0 timing belt replacement
• Exploded view - valve gear · 5 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures