Park Assist steering sensor (Spacefox/Suran) - remove and install — VW

🧭 Before you start

Fits: VW Fox (5Z)

📋 Procedure

1. Turn off the ignition, all the electrical devices, and remove the key from ignition.
2. Disconnect the BatteryA.
3. Remove the rear bumper (1)General body repairs, exterior63Bumpers.
4. Disconnect the connector (2) from Park Assist steering sensor (3).
5. Carefully press locks (arrows) and remove parking aid sensor (3)by pulling it. [Note: The supports and sensors are supplied without painting.The sensor supports must be placed before the bumper covering is painted, and the sensors must be painted before assembly.Sensors may be painted with a layer of 100 µm only. To paint the sensors, it is necessary to disconnect the connector.Avoid mechanical damages or damages caused by chemical agents to the sensors.The measurement for painting (a) is 3 + 2 mm.]

6. Slightly sand bumper lining (5) internal surface (1).
7. Remove adhesive tape protection.
8. Position supports(4) in order to align them in parallel to the upper bumper covering area (1).
9. When gluing the support, press it firmly.
10. Check sealing ring (3)correct position.
11. Fit parking aid sensor (2) to sensor support (4).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Specified values for wheel alignment, multi-link suspension, Golf
• Checking fuel system pressurisation pump G6
• Removing and installing refrigerant expansion valve 1 N636
• Servicing additional water heater -B4W/D4W-
• Removing, installing and tensioning injection pump toothed belt (engine codes AAB, AJA)