Main headlights (►06/11) - correct the assembly position — VW

🧭 Before you start

Fits: platform codes 9A2, 9A4, 9A5, 9A1, 9A3, 9A6

Don't miss

• After adjusting the headlight relative to the body, the headlights must be adjusted .

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Turn off the ignition, all the electrical devices, and remove the key from ignition.
2. Remove the radiator grille General body repairs, exterior66External equipment.
3. Loosen the fastening screw (arrow) from the headlight, on the upper section.
4. Release the fastening screws (arrows).
5. Remove the front bumper left side protection trimGeneral body repairs, exterior63Bumpers.

6. Release the fastening screw (arrow) from the headlight, on the side, by pulling the bumper covering carefully forward.
7. Loosen the fastening screw (arrow) from the headlight, on the lower section.
8. Align, in relation to the body, moving the headlight to the corresponding position.
9. Tighten the fastening bolts based on the following order: upper fastening bolt (4 Nm), lower and lateral fastening bolts (3.5 Nm). — 4 Nm (3.0 lb-ft)
10. Check the headlight assembly position for clearance uniformity. If necessary, correct.
11. Install the radiator grille General body repairs, exterior66External equipment.
12. Mount the front bumper left side protection trim General body repairs, exterior63Bumpers.
13. Check the headlight operation. [Note: After adjusting the headlight relative to the body, the headlights must be adjusted .]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Dismantling and assembling intake manifold
• Dismantling and assembling input shaft, output shaft, differential and selector forks
• Repairing gearbox housing and selector shaft
• Assembly overview - removing and installing input shaft, output shaft, differential, selector mechanism and selector forks
• Repairing selector lever and selector housing - selector mechanism with „STOP position forward“