Installing repair kit for the rearmost retaining tab: VW Touran I
Step-by-step installing repair kit for the rearmost retaining tab for the VW Touran I: 6 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touran I (1T, 2003–2015)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.0 Nm (0.7 lb-ft) | Fit new retaining tab (2) onto base of headlight, ensuring a positive fit, and tighten… |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical loads, and pull out ignition key.
- Remove headlight .
- Remove remains of old retaining bracket (1) until new retaining bracket makes a positive fit against the headlight.
- Fit new retaining tab (2) onto base of headlight, ensuring a positive fit, and tighten screws (3) to 1.0 Nm. — 1.0 Nm (0.7 lb-ft)
- Install headlight .
- Checking headlight settings and adjusting if necessary: "“Maintenance manual”"Descriptions of work
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Test solenoid valve 1 for activated charcoal filter
- Dismantling and assembling "K1" clutch housing – VW
- Removing oil seal for left flange shaft – VW Golf IV / Bora
- Draining and filling with coolant – VW BPR/BPS
- 5-speed gearbox 085 DS Lupo 3 L, Lupo FSI — Repairing clutch housing
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.