Installing handle: VW Touareg I 4.9 TDI (CBWA)

🧭 Before you start

Fits: VW Touareg I (7L, 2002–2010)

Don't miss

• To ensure insert locking lugs assume correct position in recesses in handle:
• III - Now press handle onto selector lever to stop. It must be felt to engage.

🔧 Engine codes this applies to

📋 Procedure

1. Refit assembly aid (A) (included with new handle).
2. Push clip in again.
3. Push insert onto stop in handle. [Note: To ensure insert locking lugs assume correct position in recesses in handle:]
4. Slide insert approx. 1 mm back and forth in handle by hand.
5. Insert clip (2).

6. I - Push insert into handle to stop, and then slide upwards (arrow).
7. II - Fit sleeve onto handle.
8. Move selector lever to position "„N“".
9. I - Guide sleeve carefully through sliding cover and cross-slide lying underneath.
10. When inserting, take care to guide the sleeve very carefully through cover strip. Pressing in the sleeve without taking care will break the cover strip.
11. II - Push on handle (handle pointing front to rear) to stop, then turn.
12. III - Now press handle onto selector lever to stop. It must be felt to engage.
13. Remove assembly aid (A), depress button and pull sleeve upwards.
14. Remove backing from adhesive surface and apply sticker (arrow).

Other VW procedures

• Removing and installing oil filter housing – VW Polo 6C · 3 torque figures
• Securing engine on engine and gearbox supportVAS 6095 · 4 torque figures
• Removing and installing camshaft compensating gear and drive gear wheel · 1 torque figures
• Removing and installing bearing saddle for crankshaft – VW AJS · 4 torque figures
• Checking and adjusting position of pump plungers in unit injectors · 3 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures