Installing gearbox, CC with four-wheel drive — VW

🧭 Before you start

Fits: VW CC (358, 2012–2017)

• Renewed: seals

Don't miss

• After installing, check ATF level .

📋 Procedure

1. Check for proper seating of both dowel sleeves between engine and gearbox.
2. Set gearbox in place, possible adjusting gearbox support.
3. Now install one of the engine/gearbox connecting bolts.
4. Fit and tighten all torque converter nuts. Specified torque .
5. First bolt bracket (2) to gearbox. Specified torque .

6. Raise engine and gearbox, reestablish »former seating« of bolts (1) for gearbox mounting to bracket (2) and tighten. Torque specification .
7. Install bevel box .
8. Adjust selector lever cable .
9. Renew seals on ATF pressure lines.
10. After installing, check ATF level .
11. Check coolant level and top up if necessary 19.
12. Perform basic setting by pressing Perform basic setting.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing gearbox - Vehicles with 6 cylinder fuel injection engine -
• Servicing petrol electric heater -B2L-
• Dismantling and assembling heater unit -B4W/D4W-
• Removing and installing gearbox (Transporter with short front end)
• Removing gearbox, vehicles with front-wheel drive