Injector with needle lift sender — VW
Injector with needle lift sender on VW: 4 steps, 1 torque figure, engines AFB, AKN, BAU, BDG. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B5 (3B)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Tighten retainer securing nuts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📐 53 workshop diagrams for AFB
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Guide injector cable through retainer.
- Fit retainer.
- Tighten retainer securing nuts to 10 Nm. — 10 Nm (7.4 lb-ft)
- Route cable in the plate guide provider on the camshaft bearing (arrow).
Ask TorqFix about your VW AFB — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your VW AFB — free → or sign up free to see the drawingsOther VW procedures
- Checking fuel pump relay J17 and activation - vehicles with 8-cylinder engine
- Checking electric fuel pump 2 relay J49 and activation - vehicles with 8-cylinder engine
- Removing and installing oil filter bracket – Audi TT Mk1
- Draining fuel tank – Audi Q5
- Removing and installing fuel gauge senderG – Audi A8 D4
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.