Height adjuster - remove and install — VW

🧭 Before you start

Fits: platform codes 5U4, 5U3, 5UA, 5UC, 5UB

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove B-pillar upper lining (2-door Gol) .
2. Remove B-pillar upper lining (4-door Gol/Voyage) .
3. Remove B-pillar upper lining (Saveiro - extended cab) .
4. Remove the upper B-pillar lining (Saveiro - double cab) .
5. Remove securing bolts (1).

6. Remove the seat belt height adjuster (2) from B-pillar.
7. Install the seat belt height adjuster (2) on B-pillar.
8. Tighten securing bolts (1) to (25 Nm) torque. — 25 Nm (18 lb-ft)
9. Install B-pillar upper lining (2-door Gol) .
10. Install B-pillar upper lining (4-door Gol/Voyage) .
11. Install B-pillar upper lining (Saveiro - extended cab) .
12. Install the upper B-pillar lining (Saveiro - double cab) .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing suspension strut for adaptive chassis control DCC · 1 torque figures
• Checking fuel pressure
• Removing and installing rear outer seat belts – VW Touareg II · 4 torque figures
• Removing and installing left exhaust manifold – VW Touareg II · 4 torque figures
• Removing bevel box · 1 torque figures