Removing and installing belt height adjuster, 2-door models — VW
Removing and installing belt height adjuster, 2-door models on VW: 8 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6C (2014–2017)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Remove bolt (1 |
| 40 Nm (30 lb-ft) | Unscrew bolt (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove bench seat .
- Remove backrest .
- Release sill panel moulding from fasteners in sill at transition to side panel.
- Remove side trim panel .
- Release B-pillar trims (2-door models) .
- Unscrew bolt (1) (40 Nm) and remove belt guide fitting (2) from belt height adjuster. — 40 Nm (30 lb-ft)
- Remove bolt (1) (20 Nm) and remove belt height adjuster (2) from mountings in support bracket. — 20 Nm (15 lb-ft)
- Install in reverse order of removal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Calibrating lane change assist
- Removing and installing brake caliper FN3
- Dismantling and assembling drive shaft, constant velocity joint VL107
- Removing and installing engine control unit J623 with protective housing (Polo)
- Removing and installing engine bracket, Passat, Eos and CC
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.