Golf4/Bora (1.8) AGN,AGU,AQA,ARZ,AUM,AUQ — VW

🧭 Before you start

Fits: platform codes 1.8, |, TURBO, GTI, (1.8, TURBO)

Don't miss

• Remove the power steering fluid reservoir but do not disconnect

🔧 Engine codes this applies to

📋 Procedure

Preparation and removal

1. Before disconnecting the battery cable, check the audio system security code
2. Remove the noise insulation covers
3. Hooks:
4. Remove the ancillary drive belt
5. Remove the engine support bar

6. Remove the power steering fluid reservoir but do not disconnect
7. Disconnect the throttle valve control unit vacuum line

Installation and checks

8. Refit the engine support bracket
9. Refit the engine mount
10. Bolts:
11. Fit the crankshaft pulley
12. Turn the engine 2 rotations by hand
13. Engine code
14. Add Loctite
15. Tensioning bolt:
16. Fit the tensioning bolt
17. Refit the right-hand headlight
18. Refit the engine cover

Other VW procedures

• Checking oil pressure and oil pressure switch
• Checking charge pressure regulation – VW Golf IV / Bora 1.8
• Checking fuel gauge senderG – Audi Q7
• Removing and installing fuel gauge sender – VW Golf V / Jetta
• Checking fuel pump delivery rate – Audi A8 D3
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures