Front wheel arch protector - remove and install — VW
Front wheel arch protector - remove and install on VW: 12 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 6A1, 6A5
Don't miss
- Check expansion nuts for damages and, eventually, replace them.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Tighten the front wheel arch protector in the indicated sequence, from (1) to (11), torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove the lower Poly-V belt protector
- Remove wheel Chassis, axles, steering44Wheels, tyres, vehicle dimensions.
- Remove the expansive rivet (3).
- Remove the screws (1).
- Remove front wheel arch protector (2) from mudguard. [Note: Check expansion nuts for damages and, eventually, replace them.]
- Push front wheel arch protector (2) into mudguard.
- Align front wheel arch protector (2) to bumper protector.
- Place the expansive rivet (3).
- Place all screws and tighten them in the sequence described below
- Tighten the front wheel arch protector in the indicated sequence, from (1) to (11), torque: 2 Nm. — 2 Nm (1.5 lb-ft)
- Install wheel Chassis, axles, steering44Wheels, tyres, vehicle dimensions.
- Install the lower Poly-V belt protector
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing alternator, 1.9 l 47 kW SDI engine
- Removing and installing alternator, 1.4 l 51 kW TDI engine with air conditioning system
- Removing and installing turbocharger, engine code BMT – VW ASZ
- Removing and installing airbag control unit J234 · 1 torque figures
- Installing suspension strut
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.