Front seat belt (4-door Gol, Parati, and Saveiro) - remove and install — VW
Front seat belt (4-door Gol, Parati, and Saveiro) - remove and install on VW: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Don't miss
- Turn the right seat belt 180° clockwise and the left seat belt 180° counterclockwise before the lower belt fastening.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Tighten securing bolts to a torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove the B-pillar covering .
- Loosen the belt guide screws and remove the guide.
- Loosen the seat belt inertia reel screw.
- Remove the seat belt inertia reel. [Note: Turn the right seat belt 180° clockwise and the left seat belt 180° counterclockwise before the lower belt fastening.]
- Install in the reverse sequence from the removal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing alarm horn H12, vehicles for left-hand traffic, RdW (rest of world) · 1 torque figures
- Emptying tank for reducing agent, Sharan
- Removing and installing exhaust gas temperature sender 2G448, Sharan and Tiguan
- Removing and installing clutch position sender G476, LHD vehicles
- Removing and installing luggage compartment side trim panel
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.