Fastening of the front belt - remove and install — VW
Fastening of the front belt - remove and install on VW: 6 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 5U8, 5U9, 5U2, 5U1
- Renewed: self-locking nuts
Don't miss
- For the right latch, it is not necessary to remove the seat (passenger).
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 24 Nm (18 lb-ft) | Tighten the securing bolt (2) to the torque |
| 40 Nm (30 lb-ft) | Tighten the securing bolt (1) to the torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove the left front seat (driver) . [Note: For the right latch, it is not necessary to remove the seat (passenger).]
- Remove the securing bolt (1).
- Remove the belt latch (2).
- ⚠ Replace self-locking nuts and bolts subject to angular torque — Install the belt latch (2).
- Tighten the securing bolt (1) to the torque of (40 Nm). — 40 Nm (30 lb-ft)
- Install the left front seat (driver) .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Brake shoes (Micrometric system) - remove and install
- Wheel bearing case - remove and install · 1 torque figures
- Checking intake air temperature sender – VW Passat B5 2.3 AZX
- Removing and installing oil seal on Hall sender – VW Passat B5 · 2 torque figures
- Removing and installing tank for reduction agent – VW · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.