Electric motor for the Hydraulic gearbox pump V387 - remove and install — VW

🧭 Before you start

Fits: platform codes 5U2, 5U1

Don't miss

• When replacement is necessary, the entire set "“Electric motor and hydraulic pump”" must be replaced. — Remove the gear selection mechanism .

📋 Procedure

1. ⚠ When replacement is necessary, the entire set "“Electric motor and hydraulic pump”" must be replaced. — Remove the gear selection mechanism .
2. Install the gear selection mechanism on the gearbox mounting T10108 as indicated .
3. Drain the hydraulic oil from the reservoir.
4. Remove the hydraulic oil reservoir .
5. Disconnect the connector (1).

6. Remove the fastening screws (arrows) and remove the electric motor (2).
7. Position the coupling (1) on the axle of the Hydraulic gearbox pump V387.
8. Install the electric motor (2) and tighten the fastening screws (arrows).
9. Apply NyogelG 052 817 A1 to the connector contact pins (1).
10. After installation, check and complete the tank oil level

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• 4-speed automatic gearbox 099, four-wheel drive — Removing and installing propshaft
• Removing and installing "G182" – VW Sharan I / SEAT Alhambra · 1 torque figures
• Removing multi-function switch F125 – VW
• Checking fuel tank breather: engine code AJH – VW 1.8 AJH/AWC
• Removing and installing coarse oil separator · 1 torque figures