Detaching electric drive motor and gearbox — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

🔧 Engine codes this applies to

📋 Procedure

1. Take off cap (1). Through opening in gearbox, unscrew the 3 securing nuts for torque converter (arrow). To do this, turn the crankshaft 120°.
2. Support electric drive motor with workshop craneVAS 6100 as shown.
3. Unscrew bolts (1 ... 10) from connection of gearbox to electric drive engine.
4. Remove electric drive motor with workshop craneVAS 6100.
5. Secure torque converter in gearbox with support bridge30-211 A to prevent it falling out.

6. Check whether dowel sleeves (arrows) are fitted in the electric drive motor.
7. Note installation position of bolts (1) in torque converter (2).
8. Position electric drive motor on gearbox with workshop craneVAS 6100 as shown.
9. Tighten bolts (1 ... 10) from connection of gearbox to electric drive engine.
10. Through opening in gearbox, tighten the 3 securing nuts for torque converter (arrow). To do this, turn the crankshaft 120°. Fit cap (1).

Other VW procedures

• Removing and installing radiator module – VW 3.0 TDI
• Removing and installing left exhaust manifold, bank 2 · 2 torque figures
• Dismantling and assembling engine and electric drive motor with gearbox · 1 torque figures
• Removing and installing right exhaust manifold, bank 1 · 2 torque figures
• Removing and installing drive chain for valve gear – VW
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures