Dismantling and assembling input shaft, from gearbox date 19 05 3 — VW
Dismantling and assembling input shaft, from gearbox date 19 05 3 on VW: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf IV / Bora (1J)
- Special tools named: feeler gauge
Don't miss
- Allocate retaining rings using Electronic parts catalogue (ETKA).
- Remove pliers before cylindrical roller bearing is in installation position. Retaining ring must engage in groove of clutch housing.
📋 Procedure
- First remove retaining ring from input shaft.
- Before setting up pulling device, set thrust pieceVW 431 and thrust plate40-105 on input shaft.
- Apply splitter (B) to peripheral groove for retaining ring in bearing.
- Determine and install retaining ring (see the separate procedure).
- Insert a 1.86 mm thick retaining ring (A) in groove of input shaft and press upwards.
- Measure distance between deep groove ball bearing (B) and installed retaining ring (A) using feeler gauge (C).
- Remove retaining ring used for measuring purposes.
- Determine retaining ring from table. [Note: Allocate retaining rings using Electronic parts catalogue.]
- When pulling out, squeeze together retaining ring (arrow) of cylindrical roller bearing, using pliers (C).
- When pressing in, squeeze together retaining ring (arrow) of cylinder roller bearing, using pliers (A).
- Remove pliers before cylindrical roller bearing is in installation position. Retaining ring must engage in groove of clutch housing.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Cleaning ATF pipes and ATF cooler – VW Phaeton
- 5-speed automatic gearbox 01V — Checking oil in front final drive
- Installing centre bearing for rear propshaft free of stress
- 6-speed manual gearbox 02Q — Renewing seal between gearbox and bevel box with bevel box removed
- Checking vane pump delivery pressure on 4 or 5-cylinder engine
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.