Crankshaft flange with Engine speed sensor G28 rotor (flywheel side) - remove — VW

🧭 Before you start

Fits: platform code 7X

• Timing position: the crankshaft or camshaft is set and locked during this job

Don't miss

• Place the camshaft gear on the mark (arrow A).
• Put the crankshaft in cylinder 1 TDC. The tooth marked on the camshaft gear must align with the mark "“2V”" on the flange (arrow B).
• The flange and rotor are removed together from the crankshaft with three screws M 6 × 35 mm.

🔧 Engine codes this applies to

📋 Procedure

1. Remove transmission Clutch and transmission34Drive, case.
2. Remove flywheel.
3. Remove intermediate plate.
4. Place the camshaft gear on the mark (arrow A).
5. Put the crankshaft in cylinder 1 TDC. The tooth marked on the camshaft gear must align with the mark "“2V”" on the flange (arrow B).

6. Remove the oil pan .
7. Remove the Engine speed sensor G28(arrow).
8. Loosen flange fastening screws. [Note: The flange and rotor are removed together from the crankshaft with three screws M 6 × 35 mm.]
9. Install the three M 6 × 35 mm screws in the threaded holes of the flange (arrows).
10. Turn screws alternately (max. 1/2 turn (180°) per screw), on the flange and remove the flange with the rotor Engine speed sensor G28 from the crankshaft.

Other VW procedures

• Removing and installing throttle cable – Audi A3
• Performing kick-down adaption - vehicles with automatic gearbox
• Fuel pump (pre-supply pump)G6 check valve - examine
• Removing and installing parts of the injection system
• Checking Lambda probe and Lambda regulation before catalyst
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures