Connecting front and rear silencers — VW
Connecting front and rear silencers on VW: 6 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 25 Nm (18 lb-ft) | Tighten threaded connections equally |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Secure the front silencer in the retainers. The front hose clamp remains loosely pushed onto the pipes.
- Align the rear silencer level and keep it in this position.
- Position repair retaining clip at side markings (arrow 1) and (arrow 3).
- Turn repair retaining clip (A) as illustrated.
- Tighten threaded connections equally to 25 Nm. — 25 Nm (18 lb-ft)
- Align exhaust system free of stress
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing seat cover and seat cushion for "“1/3”" bench seat (5-seater)
- Checking voltage supply of fuel pump G6, engine codes CFFA, CFFB, CFGB, CLLA
- Removing and installing headlight dipped beam bulb M29/M31
- Removing and installing tail light MX5/MX6, rear lid, Estate
- Removing and installing electronic ignition lock D9
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.