Clutch actuatorVX64 (with gearbox installed) - remove and install — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

Don't miss

• The Clutch actuatorVX64 must not be disassembled. Risk of injuries! — Disconnect the connector (arrow) to Clutch actuatorVX64.
• Carefully pull the connector to ensure proper fitting.

📋 Procedure

1. ⚠ The Clutch actuatorVX64 must not be disassembled. Risk of injuries! — Disconnect the connector (arrow) to Clutch actuatorVX64.
2. To disconnect, pull the lock (1) in the direction of the line and press the lock (2) to the side.
3. Remove the fastening bolt (1).
4. Remove the fastening bolt (2).
5. Loosen the fastening bolt (3).

6. Remove the fastening bolt (3) and remove the Clutch actuatorVX64.
7. Install the Clutch actuatorVX64 selector rod in the clutch release lever.
8. Place the Clutch actuatorVX64 until the adjustment stop and manually tighten the fastening bolt (3).
9. Install and manually tighten the fastening bolt (2).
10. Install and manually tighten the fastening bolt (1).
11. Tighten all fastening bolts. Tightening torque, see .
12. Connect the connector (arrow) to Clutch actuatorVX64.
13. Carefully pull the connector to ensure proper fitting.
14. Execute the Calibration.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing jointed shaft – VW Phaeton · 4 torque figures
• Removing and installing heat exchanger, RHD vehicles · 3 torque figures
• Topping up ATF · 6 torque figures
• Removing and installing camshaft control valves – VW · 5 torque figures
• Removing and installing tank shut-off valve · 3 torque figures