Checking wheel brake cylinder for leaks: VW Jetta VI
Step-by-step checking wheel brake cylinder for leaks for the VW Jetta VI: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Jetta VI (16, 2010–2018); platform code AV2
- Opens: brake fluid
- Renewed: wheel brake cylinder
Don't miss
- In the case of leaks or damage, it is absolutely necessary to replace the wheel brake cylinder.
📋 Procedure
- Loosen wheel bolts.
- Raise vehicle.
- Remove wheel.
- Retract brake
- Remove brake drum .
- Clean area around wheel brake cylinder for visual inspection.
- Lift dust boots (1) slightly off wheel brake cylinder (2) using removal wedge (3).
- Check whether there is brake fluid in dust collar. [Note: In the case of leaks or damage, it is absolutely necessary to replace the wheel brake cylinder.]
- ⚠ Do not blow out brake system with compressed air; the resulting dust constitutes a health hazard! — Fit and tighten wheel Running gear, axles, steering44Wheels, tyres; Specified torque for wheel bolts.
- Adjust handbrake .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing ATF cooler, round design
- Removing and installing brake caliper; Bosch ZOH BIR 38
- Removing and installing brake light switch
- Removing and installing front window regulator motor · 1 torque figures
- Removing and installing rear window channel
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.