Checking gear oil in rear final drive: VW Phaeton
Step-by-step checking gear oil in rear final drive for the VW Phaeton: 4 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Phaeton (3D)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 35 Nm (26 lb-ft) | Install and tighten plug |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Place drip trayV.A.G 1306 underneath.
- Remove plug to check gear oil.
- Fill with gear oil to lower edge of filler hole, if necessary.
- Install and tighten plug to 35 Nm. — 35 Nm (26 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Models with automatic gearbox and engine codes BBY, AUA, AHW, AKQ and APE
- Removing and installing headlight washer system reservoir
- Renewing dipped and main beam bulb
- Removing and installing starter, vehicles with 3.6 l, 206 kW injection engine, automatic gearbox AL420-6Q
- Removing and installing rain sensor G213 – VW Polo 9N
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.