Auxiliary brake light (01/07►) - remove and install — VW

🧭 Before you start

Fits: platform codes 9B1, 9B3

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Turn off the ignition, all the electrical devices, and remove the key from ignition.
2. Disconnect the BatteryA .
3. Remove the rear door upper and lower linings General body repairs, interior70Rear door lining.
4. Remove the fastening screw (arrow) on the auxiliary brake light.
5. Disengage the connector (1) and remove the auxiliary brake light.
6. Tighten the fastening screw (arrow) with (1.5 Nm) of torque. — 1.5 Nm (1.1 lb-ft)
7. Connect connector (1) and check the operation of the auxiliary brake light.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing headlight range control motor V48/V49, halogen headlight ► 01.2012
• Steering column electronics control unit J527 ► 10.2009
• Removing and installing starter, 1.6 l, 75 kW injection engine with manual gearbox MQ200-5F
• Removing and installing voltage stabiliser J532, left-hand drive · 1 torque figures
• Removing and installing reinforcing member »R« – VW Golf VI · 1 torque figures