Auxiliary brake light - remove and install — VW
Auxiliary brake light - remove and install on VW: 5 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Release fastening nuts (3 |
| 2 Nm (1.5 lb-ft) | Tighten the fastening nuts (3) to torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Turn the ignition and all electric consumers off, and remove the key from ignition.
- Disconnect the BatteryA.
- Disconnect the (2) auxiliary brake light connector.
- Release fastening nuts (3) (2 Nm) and remove auxiliary brake light(1). — 2 Nm (1.5 lb-ft)
- Tighten the fastening nuts (3) to torque (2 Nm). — 2 Nm (1.5 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Aligning dash panel in vehicle (Jetta 2005 ►, Golf estate 2007 ►) · 7 torque figures
- Removing and installing toothed belt, engine codes CMBA, CPVA, CXSA, CZCA, CPVB · 3 torque figures
- Adjusting side inclination (distance) · 7 torque figures
- Generator (Alternator)C for 1.0 and 1.6-litre (CCNA, CCRA) engines - remove and install · 6 torque figures
- Removing and installing front sealing flange – VW Passat B5 · 6 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.