Adjusting stop buffers: VW Passat B7 Variant
Step-by-step adjusting stop buffers for the VW Passat B7 Variant: 7 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B7 Variant (365, 2010–2014)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Tighten bolt (5), specified torque |
| 10 Nm (7.4 lb-ft) | Tighten stop buffer (2), specified torque for bolt (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Tighten stop buffer (2), specified torque for bolt (3): 10 Nm. — 10 Nm (7.4 lb-ft)
- Lever cover (4) out of stop buffer.
- Loosen bolt (5) on stop buffer (6) slightly until the stop buffer can be moved into uppermost position (arrow).
- Close rear lid (1) to first detent position by applying light pressure to centre area.
- Open rear lid again.
- Tighten bolt (5), specified torque: 10 Nm. — 10 Nm (7.4 lb-ft)
- Press cover (4) onto stop buffer.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing sliding sunroof seals on glass panel
- Removing and installing rear wheel housing liner
- 5-speed manual gearbox 02C, four-wheel drive — Renewing bevel box output flange oil seal (bevel box removed)
- 5-speed manual gearbox 02C, four-wheel drive — Adjusting differential
- Renewing sealing cap – VW Tiguan I
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.