Adjusting shut line: VW Sharan II / SEAT Alhambra
Step-by-step adjusting shut line for the VW Sharan II / SEAT Alhambra: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)
Don't miss
- In order to adjust the shut line (arrow a) of the sliding door(3), the screws (2) of the hinge must be loosened.
- (Dimension b) must be the same at the top and bottom.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Tighten screws of hinge, specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- In order to adjust the shut line (arrow a) of the sliding door(3), the screws (2) of the hinge must be loosened.
- Adjust shut line of sliding door (arrow a).
- (Dimension b) must be the same at the top and bottom.
- Tighten screws of hinge, specified torque: 20 Nm. — 20 Nm (15 lb-ft)
- Check the adjustment.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing moulded headliner (vehicle with sliding/tilting sunroof)
- Removing bevel box, 0AV
- Dismantling and assembling selector mechanism, - gear lever is NOT "“pushed down”" to engage reverse gear
- Removing and installing gear actuatorVX65 with gearbox installed
- Removing and installing high-voltage heater (PTC)Z115 / high-voltage heater (PTC)J848
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.