Adjusting rear sliding sunroof cover: VW Golf VII Variant
Step-by-step adjusting rear sliding sunroof cover for the VW Golf VII Variant: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf VII Variant (BA)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 7 Nm (5.2 lb-ft) | Tighten bolts on left and right (4 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Pull off inner seal (5).
- Loosen bolts (4) for rear sliding sunroof cover (3).
- Adjust rear sunroof panel (3) according to dimensions .
- Tighten bolts on left and right (4). Specified tightening torque: 7 Nm. — 7 Nm (5.2 lb-ft)
- Position seal (5) on assembly frame.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing control unit and hydraulic unit, RHD vehicles, ABS
- Removing and installing brake shoes
- Removing and installing oil supply line and turbocharger support
- Removing and installing moulded headliner (vehicle with sliding/tilting sunroof)
- Removing bevel box, 0AV
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.