Adjusting locking cable (vehicles with ignition key withdrawal lock) — VW

🧭 Before you start

Fits: platform codes 1H1, 1H2

• Timing position: the crankshaft or camshaft is set and locked during this job
• Special tools named: locking pin

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Move selector lever to position "„1“".
2. Turn ignition key to right (start position) and release.
3. Adjust clearance between lever (1) and locking pin (2) to 0.7 mm by sliding sleeve of locking cable.
4. Tighten support bracket bolt for locking cable in this position to 6 Nm. — 6 Nm (4.4 lb-ft)
5. Move selector lever to position "„P“" and turn ignition key to end position.
6. Pull out ignition key.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Vehicles with 4-speed automatic gearbox 001
• Removing and installing pop-up washer spray jet cylinder, vehicles as of 04.05
• Adjusting tailgate/boot lid
• Removing and installing pedal cluster
• 5-speed manual gearbox 02T — Dismantling and assembling differential