Adjusting guide pins: VW Sharan I / SEAT Alhambra
Step-by-step adjusting guide pins for the VW Sharan I / SEAT Alhambra: 3 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 8 Nm (5.9 lb-ft) | Perform this adjustment on left and right by moving guide pins on D-pillar, then tighten… |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Unscrew the cross-head screw (2) on the left and right and then remove cover for guide pins (1).
- Have a second mechanic carefully close the rear lid and check from the inside the vehicle whether the guide wedges (1) are pressed evenly, about 10 mm, forwards by the guide pins (2).
- Perform this adjustment on left and right by moving guide pins on D-pillar, then tighten Torx screws of guide pins to 8 Nm. — 8 Nm (5.9 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing desiccant bag or cartridge, Keihin · 1 torque figures
- Removing and installing rear vents · 1 torque figures
- Lowering rear axle, front-wheel drive
- Removing and installing lower transverse link, four-wheel drive
- Removing and installing lock carrier
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.