Adjusting door — VW
Adjusting door on VW: 4 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 138
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 36 Nm (27 lb-ft) | Shift the door within the oversized holes (second mechanic required) and tighten the… |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- To loosen bolt (7), lower A-pillar trim must be removed General body repairs, interior70Interior trim; Removing and installing A-pillar trim.
- To loosen bolt (4) on driver's side, dash panel must be removed General body repairs, interior70Dash panel; Removing and installing dash panel.
- To loosen bolt (4) on front passenger side, dash panel must be removed General body repairs, interior70Dash panel; Removing and installing dash panel
- To loosen bolt (4), heater and air conditioning unit must be removed Heater and air conditioning system87Front heater and air conditioning unit; Removing and installing heater and air conditioning unit.
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.