Adjust the timing belt — VW
Adjust the timing belt on VW: 7 steps, 3 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Install the mechanical distribution's front cover |
| 25 Nm (18 lb-ft) | Install the crankshaft pulley/vibration damper |
| 25 Nm (18 lb-ft) | Install the Poly-V belt's tensioning device |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Adjust the timing belt, loosening the ClipT 40011 and the Tensioning screwT 10092.
- Turn the crankshaft by two turns and check whether the marks on the camshaft and crankshaft are aligned with the respective reference points.
- Install the crankshaft pulley/vibration damper. Tightening torque: 25 Nm. — 25 Nm (18 lb-ft)
- Install the mechanical distribution's front cover. (Install fastening screws with Liquid sealD 000 600 A2. Tightening torque: 10 Nm. — 10 Nm (7.4 lb-ft)
- Install the mechanical distribution upper cover.
- Install the Poly-V belt's tensioning device. Tightening torque: 25 Nm. — 25 Nm (18 lb-ft)
- Install the Poly-V belt: .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft · 47 torque figures
- Adjusting valve timing · 83 torque figures
- Removing and installing camshafts · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing brake servo, LHD vehicles with 4-cyl. petrol engine
- Removing and installing condenser, vehicles with 5-cylinder petrol engine · 3 torque figures
- Installing 7-seater fixtures · 1 torque figures
- Removing and installing control housing
- Removing gearbox, vehicles with 1.6 l/75 kW MPI engine
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.