8-speed automatic gearbox 0C8 — Removing and installing auxiliary hydraulic pump for gear oil V475 or V476 — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

• Opens: gearbox oil

Don't miss

• Do not run engine or tow vehicle with auxiliary hydraulic pump removed or when there is no ATF in gearbox. — Remove gearbox noise insulation.
• Before removal, cover the area around the auxiliary hydraulic pump with a sufficient number of cloths.
• After installing, fill up ATF, check ATF level and top up .

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. ⚠ Do not run engine or tow vehicle with auxiliary hydraulic pump removed or when there is no ATF in gearbox. — Remove gearbox noise insulation.
2. Put used oil collection and extraction unitV.A.G 1782 underneath.
3. Unscrew and remove ATF inspection plug (A).
4. Unscrew and remove overflow pipe (C).
5. Drain ATF.

6. Install overflow pipe (C) again and tighten to 2 Nm. — 2 Nm (1.5 lb-ft)
7. Screw in ATF inspection plug (A) hand-tight with new seal (B). [Note: Before removal, cover the area around the auxiliary hydraulic pump with a sufficient number of cloths.]
8. Pull connector (A) off and undo bolts (1) for auxiliary hydraulic pump.
9. Remove auxiliary hydraulic pump.
10. Thoroughly clean oily areas on gearbox.
11. Install auxiliary hydraulic pump with a new gasket.
12. After installing, fill up ATF, check ATF level and top up .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures