TorqFix

6-speed manual gearbox 02Q — Checking gear oil — VW

6-speed manual gearbox 02Q — Checking gear oil on VW: 10 steps. What to remove, in what order, and what to check after.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

10 steps

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018), VW Golf V / Jetta (1K, 2003–2009); platform code AJ5

📋 Procedure

  1. Remove noise insulation General body repairs, exterior50Noise insulation.
  2. Position used oil collection and extraction unitV.A.G 1782 under gearbox.
  3. To check gear oil, remove oil plug (arrow).
  4. Screw in plug (arrow) with new seal.
  5. Tighten bolt (arrow) to specified torque .
VW? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove oil plug (arrow).
  2. Fill with gear oil to lower edge of filler hole.
  3. Screw in plug (arrow) with new seal.
  4. Tighten bolt (arrow) to specified torque .
  5. Install noise insulation General body repairs, exterior50Noise insulation.

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.