TorqFix

5-speed manual gearbox 02G, four-wheel drive — Checking oil in manual gearbox with bevel box — VW

5-speed manual gearbox 02G, four-wheel drive — Checking oil in manual gearbox with bevel box on VW: 11 steps.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

11 steps

🧭 Before you start

Fits: platform code 70A

📋 Procedure

  1. Remove noise insulation tray below engine and gearbox.
  2. Remove noise insulation tray from gearbox, if present.
  3. To check gearbox oil, remove oil plug (arrow).
  4. Tighten bolt (arrow) to specified torque .
  5. Remove oil plug (arrow).
VW? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Fill with gear oil to lower edge of filler hole.
  2. Tighten bolt (arrow) to specified torque .
  3. Start engine, engage gear and allow gearbox to turn for approx. 2 minutes.
  4. Stop engine and remove plug (arrow).
  5. Top up oil to lower edge of filler hole again.
  6. Tighten bolt (arrow) to specified torque .

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.