X-trail T32 1.6 R9M — NISSAN
X-trail T32 1.6 R9M on Nissan: 18 steps, engines R9M. What to remove, in what order, and what to check after.
Workshop procedure for NISSAN — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 1.6, DCI
🔧 Engine codes this applies to
📋 Procedure
- Turn the ignition off
- Wait for 3 minutes
- Open the driver's window
- Until the window is fully open
- Release the switch
- Close the driver's window
- Press and hold the power window close switch
- Until the window is fully closed
- Wait for more than 2 seconds
- Release the switch
- Check for correct operation
- The procedure is complete
- Repeat the procedure for the passenger's window
Other NISSAN procedures
- Nissan Micra K12 CR timing chain replacement
- Nissan non type specific 2.0 dCi timing chain replacement
- Nissan X-Trail T30 QR20, 25 QR20DE timing chain replacement
- Nissan X-Trail T31 2.4 QR25DE timing chain replacement
- Nissan Kubistar 1.5 dCi auxiliary belt replacement
- Nissan NV200 1.5 dCi K9K timing belt replacement
- Nissan Cube, Tiida 1.5 dCi K9K/K9K-728 timing belt replacement
- Nissan Primera 1.9 dCi F9Q timing belt replacement
- Nissan Juke 1.5 dCi K9K timing belt replacement
- Qashqai - HR16DE - RS5F92R
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.