Interstar (G9U-632) with FAP — NISSAN
Interstar (G9U-632) with FAP on Nissan: 11 steps, engines G9U-632(B6). What to remove, in what order, and what to check after.
Workshop procedure for NISSAN — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 2.5, DCI, 146, FAP
🔧 Engine codes this applies to
📋 Procedure
- Complete the procedure
- Within 10 seconds
- Check that the accelerator pedal is fully released
- Turn the ignition on
- Press and hold the accelerator pedal
- Press and release the brake pedal 3 times
- Release the pedals
- Wait for 5 seconds
- The maintenance key disappears
- The system is reset
Other NISSAN procedures
- G9U_2.5_CDTi_fuel pump timing
- Movano with DPF G9U-632
- Opel Movano II 2.5 CDTi G9U-632 timing belt replacement
- Master II (G9U-632)/ Trafic II (G9U-630, M9R) with FAP
- Nissan Micra K12 CR timing chain replacement
- Nissan non type specific 2.0 dCi timing chain replacement
- Nissan X-Trail T30 QR20, 25 QR20DE timing chain replacement
- Nissan X-Trail T31 2.4 QR25DE timing chain replacement
- Nissan Kubistar 1.5 dCi auxiliary belt replacement
- K9K belt (Qashqai)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.