TorqFix

Daily my02-07, my10 (F1A) belt — IVECO

Daily my02-07, my10 (F1A) belt on Iveco: 40 steps, engines F1AE0481A, F1AE0481B, F1AE0481F, F1AE0481G.

Workshop procedure for IVECO — the exact step sequence and torque figures, straight from real workshop data.

40 steps 8 engine codes

🧭 Before you start

  • Special tools named: torque wrench

📋 Procedure

Preparation and removal

  1. Loosen the tensioner pulley
  2. Remove the air-conditioning belt
  3. Or:
  4. Cut the belt(s) and remove
  5. Alternator belt:
F1AE0481A? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Loosen the tensioner pulley
  2. Use a wrench
  3. Remove the alternator belt
  4. Remove the special tool
  5. Or:
  6. Alternator belt:

Installation and checks

  1. Refit the alternator belt
  2. Renew the air-conditioning belt
  3. Refit the air-conditioning belt
  4. Tension the tensioner pulley
  5. Use the special tool
  6. Use a torque wrench
  7. Tighten the tensioner pulley bolt
  8. Turn the engine 2 rotations clockwise
  9. Check for correct fitting
  10. Check the tension of the belt
  11. The tension is set when the tension gauge indicates a value of:
  12. Refit the engine lower cover

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix → · How these pages are made →

Workshop data on this page last updated 20 Sep 2026.