Auxiliary belt replacement: Ford C-Max 2010- 1.6 Duratec anc (IQDA, IQDB, MUDA, PNDA)

🧭 Before you start

Fits: platform codes 1.6, DURATEC, 16V, TI-VCT, FFV, |

Don't miss

• The ancillary drive belt can only be fitted once. When removal is required, always fit a new belt
• Do not turn the engine anti-clockwise
• Ensure the belt is correctly positioned in the grooves

🔧 Engine codes this applies to

📋 Procedure

Preparation and removal

1. Note: The ancillary drive belt can only be fitted once. When removal is required, always fit a new belt
2. Note: Do not turn the engine anti-clockwise
3. Remove the engine lower cover
4. Fit the special tool
5. Cut the belt(s) and remove

6. Turn the special tool anti-clockwise

Installation and checks

7. Fit the ancillary drive belt
8. Position the belt as shown
9. Turn the special tool clockwise until the belt is installed
10. Note: 2 spanners are required
11. Remove the special tools
12. Turn the engine 2 rotations by hand
13. Ensure the belt is correctly positioned in the grooves
14. Repeat the procedure if required
15. Refit the engine lower cover

Other FORD procedures

• Tourneo/Transit Connect TDDi/TDCi (w/o chain)
• Ford Mondeo 1.8 SCi CFBA timing chain replacement
• Ford Mondeo 2.5 V6 LCBD timing chain replacement
• Ford Focus C-max 1.8, 2.0 Duratec-HE timing chain replacement
• Ford Transit95 2.0 DOHC NSF/NSG timing chain replacement
• Ford Mondeo 39 1.8 TDCi timing belt replacement
• Ford Ka\Fiesta 02, Duratec 3.2 timing chain replacement
• Ford Focus 1.8, 2.0 Duratec timing chain replacement
• Ford 1.6TDCi -Euro5 renewal DPF removal
• Focus / C-Max my04 DPF warning light reset