TorqFix

Timing belt replacement: Fiat Ulysse 2.0 RFV Ancill drive (XU10J4R)

Step-by-step timing belt replacement for the Fiat Ulysse 2.0 RFV Ancill drive (XU10J4R): 19 steps. What to remove, in what order, and what to check after.

Workshop procedure for FIAT — the exact step sequence and torque figures, straight from real workshop data.

19 steps 1 engine code

🧭 Before you start

  • Timing position: the crankshaft or camshaft is set and locked during this job
  • Special tools named: locking pin

🔧 Engine codes this applies to

XU10J4R(RFV)

📋 Procedure

Preparation and removal

  1. Disconnect the battery
  2. Remove the front right wheel
  3. Remove the front right splash guard
  4. Support the engine
  5. Remove the right-hand engine support
XU10J4R(RFV)? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove the timing belt cover
  2. Remove the reinforcement brace
  3. Move the coolant pipe aside slightly
  4. Loosen the bolts
  5. Remove the ancillary drive belt
  6. Fit the locking pin

Installation and checks

  1. Remove the locking pin
  2. Tighten the bolts
  3. Refit the reinforcement brace
  4. Fit the timing belt cover
  5. Refit the right-hand engine support
  6. Refit the front right splash guard
  7. Refit the front right wheel
  8. Reconnect the battery

Other FIAT procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix → · How these pages are made →

Workshop data on this page last updated 20 Sep 2026.