Securing engine to engine and gearbox stand — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

• Special tools named: VAS 6101

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Detach vacuum hose (1).
2. Detach air intake hose (2) from throttle valve module.
3. Attach the shackle10-222 A/12 to the engine lifting eye (rear right).
4. Attach hook10-222 A/2 to shackle10-222 A/12.
5. Attach the lifting tackle3033 to hook10-222 A/2 and workshop hoistVAS 6100 with lift arm extension (workshop hoist)VAS 6101 as shown in the illustration.
6. Lift engine off the support elements on scissor-type assembly platformVAS 6131 A.
7. Remove engine mounting with engine support (left-side).
8. Secure engine to engine and gearbox supportVAS 6095 with bracket for V8 engine, Audi S4, allroad quattroVAS 6095/1-6 or bracket for V8 engine, Audi S4, allroad quattroVAS 6095/1-6A, as shown in the illustration. Tightening torque: 42 Nm. — 42 Nm (31 lb-ft)

Other AUDI procedures

• Removing and installing exhaust manifold (left-side) – Audi · 4 torque figures
• Removing and installing drive chain for valve gear – Audi · 1 torque figures
• Removing and installing oil filter housing – Audi A8 D3
• Removing lock carrier – Audi A6 C5
• Removing and installing coolant pipe (right-side) – Audi · 1 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures