6-cylinder direct petrol injection engine (3.2 ltr. 4-valve), mechanics — Securing engine to engine and gearbox support — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

• Timing position: the crankshaft or camshaft is set and locked during this job
• Special tools named: VAS 6101, VAS 6095/1

Don't miss

• To adjust to the centre of gravity of the assembly, the perforated rails of the support hooks must be positioned as shown.
• The support hooks and retaining pins on the lifting tackle must be secured with locking pins (arrows). — Unplug electrical connector (1) from engine mounting (right-side).

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 26 workshop diagrams for AUK

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Attach the lifting tackle2024 A to engine and workshop hoistVAS 6100 with lift arm extension (workshop hoist)VAS 6101 as shown in the illustration. [Note: To adjust to the centre of gravity of the assembly, the perforated rails of the support hooks must be positioned as shown.]
2. ⚠ The support hooks and retaining pins on the lifting tackle must be secured with locking pins (arrows). — Unplug electrical connector (1) from engine mounting (right-side).
3. Unscrew bolts (arrows) and remove engine support (right-side).
4. Unplug electrical connector (1) from engine mounting (left-side).
5. Unscrew bolts (arrows) and remove engine support (left-side).
6. Using bracket VAS 6095/1-5, secure engine to engine and gearbox supportVAS 6095 as shown in the illustration. Tightening torque: 40 Nm. — 40 Nm (30 lb-ft)

Other AUDI procedures

• Detaching multitronic gearbox from engine · 1 torque figures
• Removing and installing front exhaust pipe (left-side) with catalytic converter
• Removing and installing front exhaust pipe (right-side) with catalytic converter
• Separating engine from multitronic gearbox · 1 torque figures
• Removing and installing timing chain covers (left and right)
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures