Replacing front seat heater elements — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

Don't miss

• The heater element is bonded to the padding and can only be installed once.
• Secure and route detached connection wires (2) so they are not kinked and do not chafe.If the wiring is not routed correctly, it may chafe or become damaged.

📋 Procedure

1. Remove front seat with longitudinal adjustment .
2. Remove front seat without longitudinal adjustment .
3. Remove seat cover.
4. Remove backrest cover .
5. Disconnect connector between heater elements in seat and backrest. [Note: The heater element is bonded to the padding and can only be installed once.]

6. Pull heater elements (3) off seat padding/backrest padding (1).
7. Align heater elements (3) on seat surface/backrest surface (1).
8. Remove protective foil on adhesive side and stick heater elements to padding. [Note: Secure and route detached connection wires (2) so they are not kinked and do not chafe.If the wiring is not routed correctly, it may chafe or become damaged.]
9. Connect 2 heater element connectors (seat and backrest).
10. Install covers .
11. Install front seat with longitudinal adjustment .
12. Install front seat without longitudinal adjustment .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Adjusting the brake shoes for the handbrake and the rear handbrake cables, LT 28/35 · 1 torque figures
• Adjusting the brake shoes for the handbrake and the rear handbrake cables, LT 46 · 1 torque figures
• Removing and installing inlet grilles · 2 torque figures
• Renewing bracket of refrigerant lines · 2 torque figures
• Removing and installing alternator, 1.9 l diesel engine, unit injector (TDI)