Replacing connecting pipe for spray jet: Audi A6 C5

🧭 Before you start

Fits: Audi A6 C5 (4B)

• Renewed: drive shaft

📋 Procedure

1. Remove spray jet .
2. Remove the wiper arm .
3. Remove the lower rear lid trim 70.
4. Detach water hose (1) from connecting pipe (3) of spray jet.
5. Screw out bolts (arrows) and detach cover (2).

6. Replace drive shaft.
7. Working from inside, insert connecting pipe (2) in cover (1).
8. Fit the new seal on the rear window wiper motor.
9. Carefully insert connecting pipe in drive shaft and screw on cover.
10. Press water hose onto spray jet connecting pipe.
11. Fit the lower rear lid trim 70.
12. Adjust the wiper arm .
13. Insert spray jet with new O-ring in connecting pipe.
14. Adjust spray jet .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing locking cable at shift mechanism with Tiptronic
• Removing and installing brake master cylinder together with brake servo unit
• Removing and installing reservoir with block connections
• Removing and installing lock carrier with ancillary components
• Safety regulations for handling pyrotechnic belt tensioners