Renewing oil seal for stub shaft on bevel box (right-side) — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

• Opens: gearbox oil

📋 Procedure

1. Raise vehicle.
2. Remove noise insulation (1) and (2)General body repairs, exterior66Noise insulation; Exploded view - noise insulation.
3. Remove nuts (1) and detach heat shield for drive shaft (right-side).
4. Remove drive shaft (right-side) Running gear, axles, steering40Drive shaft; Removing and installing drive shaft.
5. Detach circlip (1) and O-ring (2) from stub shaft.

6. Place used oil collection and extraction unitVAS 6622A or drip tray below bevel box.
7. Lightly oil outer circumference of new oil seal and fill space between sealing lips (arrow) about half full with sealing greaseG 052 128 A1.
8. Drive in new oil seal onto stop (take care to keep oil seal straight).
9. Then fit new circlip (1) and new O-ring (2).
10. Grease splines of stub shaft.
11. Install drive shaft (right-side) Running gear, axles, steering40Drive shaft; Removing and installing drive shaft.
12. Check gear oil level and top up as required .
13. Install heat shield for drive shaft (right-side) .
14. Install noise insulation General body repairs, exterior66Noise insulation; Exploded view - noise insulation.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking exhaust gas temperature sender – Audi A4 B5 2.7 ASJ
• Dismantling and assembling selector lever – Audi A6 C5
• Removing and installing fuel filter - vehicles with 6-cylinder engine
• Adapting kick-down function - vehicles with automatic gearbox
• Removing and installing door seal – Audi TT Mk1