Removing and installing door seal: Audi TT Mk1

🧭 Before you start

Fits: Audi TT Mk1 (8N)

📋 Procedure

1. Pull door seal all around off door flange and out of seal rails at top and at side window.
2. First press door seal into seal rail at B-pillar (top) (arrow b).
3. Then press door seal into seal rail at A-pillar (top) (arrow a).
4. At roof frame, first press door seal in at centre, then along entire length of seal rail.
5. Push door seal into seal rail at bottom of side window.

6. Then push seal fully into seal rail in area of side window, starting from the centre.
7. Press door seal onto door flange at B-pillar (bottom) (arrow c).
8. Then push door seal on between side window and B-pillar (bottom), starting in centre.
9. Press door seal onto door flange at A-pillar (bottom) (arrow d).
10. Then press door seal onto door flange between A-pillar and B-pillar (bottom), starting in centre.
11. Press door seal on completely between A-pillar (bottom) and A-pillar (top), starting in centre.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing headlight range control motor – Audi
• Removing and installing immobiliser control unit J362 - vehicles up to model year 1997 · 1 torque figures
• Checking charge pressure sender G31 - engine codes ANB, APU, ARK, ATW
• Removing and installing injector with needle lift sender G80
• Removing and installing pistons – Audi A3