Renewing inner seal: Audi Q5

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017); platform code 83

Don't miss

• Bonding surface must be free of dust and grease.

📋 Procedure

1. Remove glass panel (front) .
2. Remove glass panel (rear) .
3. Pull inner seal (2) off mounting frame (1).
4. Remove any residual adhesive with adhesive strip removerVAS 6349.
5. Bonding surface must be free of dust and grease.

6. Clean entire bonding surface with cleaning fluidD 009 401 04.
7. Wipe bonding surfaces of mounting frame with primer cloth supplied with seal.
8. Position inner seal (2) on bonding surfaces of mounting frame (1) so that joint is in centre of roof opening (rear).
9. Peel off protective film of adhesive strip (3) of new inner seal section by section and press on the seal.
10. Compress inner seal evenly along its entire length to take up any excess length.
11. Press inner seal evenly and all around twice using roller3356.
12. Install glass panel (rear) .
13. Install glass panel (front) .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing oil seal for output shaft – Audi A3
• Removing and installing manual release cable in passenger compartment
• Removing and installing control motor V299 (with a "“Mix”" or "“High”" air conditioner)
• Renewing camshaft – Audi Q7
• Removing and installing 3rd row seat – Audi Q7